Q-pod Quartz Crystal Monitor

The Capabilities of a Traditional QCM at a Fraction of the Size and Cost

The new INFICON Q-pod™ transducer is a small, inexpensive, accurate way to measure thin film deposition rate and thickness. Setup and operation couldn't be easier. Connect the Q-pod BNC connector to the signal cable from a QCM sensor. On the other side, a standard USB cable connects to your PC. No external oscillator or power source is required. Load the free Q-pod software on your PC and you're ready to go. Q-pod software displays rate, thickness, frequency, crystal life, and a graph of rate versus time, for up to 8 Q-pods simultaneously. Q-pod readings can be logged to disk in spreadsheet friendly comma-delimited format.

Features at a Glance

• Simplest and least expensive QCM available anywhere
• Connect directly to your PC's USB ports - up to 8 Q-pods
• Windows-based software included for operation and data logging
• Weighs less than 2 ounces and small enough to fit in a shirt pocket

ASSOCIATED TECHNICAL INFORMATION

Brochures and Datasheets:

Brochure - Q-pod Quartz Crystal Monitor

Operations and Maintenance Manuals:

Operating Manual - Q-pod Quartz Crystal Monitor

Software:

Software - Q-Pod_SETUP_V1.09